Omega-speaker-systems iDRN-PS-1000 User Manual

LN+-USAMADEINUser’s Guidewww.omega.come-mail: [email protected]®®Shop on line atiDRN-PS-1000UNIVERSAL SWITCHING POWER SUPPLYCompact DIN-Rail 24 Volt

484.1 Block Diagram of Power SupplyFigure 4.1 — Block Diagram4.2 WiringWarning: Do not turn on the ac power to the power supplyunit until you have co

49INPUT AND OUTPUT CONNECTIONS4.2 Wiring (Continued)115Vac - Single phase power wiringFigure 4.2— Wiring for 115Vac - Single PhaseLN+-Output Voltage(f

4.3 Wiring (Continued)230Vac - Two phase power wiringFigure 4.3— Wiring for 230Vac - Two Phase INPUT AND OUTPUT CONNECTIONS410LN+-Output Voltage(for s

SPECIFICATIONS511INPUT POWERInput Voltage: 115 - 240Vac ±10%Frequency: 50/60 HzCurrent: 0.400A @ 103Vac0.190A @ 265VacOvervoltage Protection: 275 Volt

SPECIFICATIONS512GENERALOperating Temperature: 23° to 122°F(-5° to 50°C)Storage Temperature: -40° to 176°F(-40° to 80°C) Mounting: 35mm DIN RailSize:

DIMENSIONS613

INPUT AC VOLTAGE / POWER OUTPUT714Example: If ambient is 50ºC, maximum wattage is 21W max. for120-265Vac. If unit is operated at 21W at an input volta

NOTES15

NOTES16

WARRANTY/DISCLAIMEROMEGA ENGINEERING, INC. warrants this unit to be free of defects in materials andworkmanship for a period of 13 months from dat

Servicing North America:USA:One Omega Drive, P.O. Box 4047ISO 9001 CertifiedStamford, CT 06907-0047TEL: (203) 359-1660 FAX: (203) 359-7700e-mail: info

M2540/0202Where Do I Find Everything I Need for Process Measurement and Control? OMEGA…Of Course!Shop on line at www.omega.comTEMPERATUREThermocoupl

1. General Information and Features 22. Safety Considerations 33. Installation and Removal 43.1 Installation Clearance 53.2 Mounting on DIN Rail 63.3

The compact iDRN power supplies are designed tosupply well-regulated 24 volt DC power to sensors,signal conditioners, data acquisition systems andhigh

SAFETY CONSIDERATIONS23This device is marked with the international Caution symbol. It is important to read this manual before installing or commiss

If a rail assembly is to be transported, thendisconnection, dismounting and separatepacking of the power supply isrecommended.For units that must be s

3.1 Installation ClearanceEnsure that there is enough room for mounting the power supply unit. There should be a minimum of 1" [25mm] spacingto

3.2 Mounting on DIN RailTo install unit onto DIN Rail1. Tilt unit, position mounting slot onto DIN Rail, as shown.2. Push unit towards DIN Rail and i

373.3 Removal of Unit1. Insert flat screw-driver into tab and push downwards.2. Unit will detach from DIN Rail.Figure 3.3 — Removal of UnitINSTALLATI