http://www.omega.come-mail: [email protected] DPS3301 Series Wall-Mount Programmable Temperature Monitor
Page 10 'PROGRAM CONTROLLER' MODE Display Time On entering Program Controller mode, the very first step lets you program is the dis
Page 11 Cold Junction adjustment: After setting Heat/Cool mode, the next parameter is the cold junction reference temperature adjustment. The
Page 12 NOTE 1: The unit must be powered up for at least ten minutes before any adjustments are made. NOTE 2: For calibrating units with RT
Page 13 Programming Limit 3: As Process Limit: If Limit 3, in the above step, was configured as a Process limit, then the message displayed
Page 14 energized. In Mode 1 the timer is ON for a programmed amount of time after a temperature limit is reached (limit1 for Timer 1 and Limi
Page 15 Audio Alarm On/Off: This unit supports an audio alarm option which comes on when ever a limit value is exceeded. This alarm can be tu
Page 16 setpoing will be indicated. Deviation Alarm: Limit 4 has the capability to work either as process or as deviation alarm. This configur
Page 17 limit alarms. (Check model number printed on the unit for option). If ordered with relays, then these relays are programmed during Setup
Page 18 To display Timer #1 value, push the TIME key twice. The first push shows elapsed time, while the second push will first display 'tr
Page 19 HIGH AND LOW PEAKS A useful feature provided by the DPS3301 system is its ability to track high and low temperature peaks. This funct
Page 2 SPECIFICATIONS...
Page 20 ‘SIGNAL CONNECTOR’ in figure 4. Also indicated are the input signal’s positive and negative polarities for thermocouple connection. The
Page 21 FIG 4. DPS3301 Series TERMINAL COMPARTMENT 1 2 3 4 5 6 7 8 9 10 11 12 13 14 POSITIVE SIGNAL NEGATIVE SIGNAL GAIN ADJUST OFFSET
DIRECT INTERFACE TO UNIVERSAL RELAY MODULE For high amperage loads, DPS3300 series units can be used in conjunction with Universal Relay Module (M
Page 23 MOUNTING 120mm 4.72” PICTURE HANGING-TYPE FIXTURE FOR MOUNTING SCREW MOUNTING SCREW SLOTS (Mount Screws from front—see picture below )
Page 24 Page 24
Page 25 Page 25
Page 26 M4300/0907
Page 3 RESETTING:...
Page 4 SPECIFICATIONS Typical @ 25 C and rated supply voltage unless otherwise specified. INPUTS: • Input types: J,K,T,E,R,S,B t/c, RTD, Vol
Page 5 DESCRIPTION Housed in a wall-mount, water-tight plastic enclosure, the DPS3301 Series is a powerful temperature monitor/indicator. It ac
Page 6 How to Reset and Program Thermocouple Type (or RTD) How to Reset and Program Thermocouple Type (or RTD) A DPS3301-TC that is calibrated
Page 7 SEE SETUP ON HOW TO SELECT ONE OF THE DISPLAY MODES. RETAINING USER SETTINGS ON POWER DOWN DPS3301 saves all the programmed para
Page 8 FLOW CHART PROGRAM CONTROLLERBack to SETUP COLD JUNCTION CALIBRATION INPUT CALIBRATION DISPLAY TIMEDISPLAY OPTION a. Process b
Page 9 SETUP MODE Setup is used for configuring various parameters of DPS3301 unit. These parameters include entering limits, timers, dead-b
Comments to this Manuals